Rocwood 2.5 Ton Low Profile Trolley Jack & 3 Ton Folding Axle Stand Kit - [SG-RWTJ2.5+RWFAS3]

Rocwood 2.5 Ton Low Profile Trolley Jack & 3 Ton Folding Axle Stand Kit - [SG-RWTJ2.5+RWFAS3]

The RocwooD RWTJ2.5 low profile trolley jack is a compact and portable accessory. It is study and small along with comes with a carry handle. It can help you change a tire or sort any issue under your car. The jack is manufactured from heavy-duty steel with a durable weld construction, providing a long-lasting service life. It is equipped with rear rotating castors for easy control and manoeuvrability.

The jack has a capacity to lift up to two and a half tonnes and is suitable for most cars and comes with an automatic safety overload valve. The built-in one-piece hydraulic unit with pump-through action is designed to prevent the handle from locking at maximum ram extension. The jack has a height range of 85mm to 380mm.

The RocwooD RWTJ2.5 low profile trolley jack is the perfect accessory to help you change a tire or sort any issue under your car. The compact design is paired perfectly with a handy integrated carry handle, making life easier when there is a need to transport the jack. The product is the ideal size for keeping in the garage or storing in the boot of your car when on the move. No job is too tough for the RWTJ2.5!

IMPORTANT

The jack can be tilted during shipping, allowing air to enter the cylinders. As a result, when you first pull a new jack out of the box, it’s critical to bleed out the air before using it. Additionally, it would be best to repeat this practice monthly and/or whenever you notice any lapses in lifting capacity. Bleeding it every month will help your jack perform at its best. To bleed your lift, follow the steps below:

• With the valve open, pump ten times.
• Close the valve and elevate it to the full height.
• Continue to pump ten times while at full extension. Lower the cylinder by releasing the valve.
• If required, repeat two more times to expel all air from the cylinder.
• Most of the time, this will completely bleed the jack. If not, gently unscrew the oil filler plug on the side after the cylinder has been freed and lowered to help remove any trapped air.

• An axle stand is a specialist tool used to support cars and other vehicles that have been lifted off the ground to access the underside. They are raised using hydraulic jacks to carry out maintenance or make repairs including changing the oil or fixing an exhaust pipe. Axle stands are made from hardwearing, load-bearing metals like aluminium, steel or cast iron which will not slip, break or twist when exposed to the weight of a car.
• Axle stands are more robust than jacks because they do not contain hydraulic or mechanical parts which can wear out over time. They are also less prone to shifting position under stress, movement which could cause the vehicle to fall.
• When using axle stands, it is important to ensure that they are suitable for the vehicle you will be supporting and will be able to support its full weight. It is also important to place chocks (wheel wedges) beneath the wheels opposite the end of the car you are raising – i.e. beneath the front wheels if you are raising the back of the vehicle, and against the back wheels if you are raising the front. Safety is always an important consideration but especially so when fatal accidents are a possibility.